Polaris 2015 Slingshot - Manual (Page 75)

73
MAINTENANCE
Headlamp Bulb Replacement
When servicing a halogen lamp (bulb), avoid touching the lamp with bare fingers. Oil from
your skin leaves a residue, causing a hot spot that will shorten the life of the lamp. If fingers
do touch a lamp, clean it with denatured alcohol.
Outer Headlamps
1. Pull the sealing boot away from the back of the bulbs and housing.
2. Press the looped end of the wire bulb retainer clip and swing the end toward the center of
the bulb to release it from the latch tab.
3. With the wire connector attached, pull the bulb out.
4. Disconnect the wire harness. Install the new bulb and secure the retainer.
5. Reinstall the sealing boot. Make sure it seals tightly around the bulb base and lens to
prevent condensation.
Center Headlamps (if equipped)
1. Disconnect the headlight wiring harness at the rear of the headlights.
2. From the rear of the headlight, grasp the bulb housing and rotate it counter-clockwise to
remove it.
3. Install the new bulb and rotate it clockwise to secure it.
4. Reconnect the wiring harness.
LED Light Assemblies
LED lights are not serviceable. If one of the
LED lamps fails to illuminate, the entire light
assembly must be replaced.
1. Remove the rear body panel to access the
light assembly.
2. Remove the screws securing the light
assembly to the vehicle (taillight assembly
shown).
3. Unplug the electrical connector from the
light assembly.
4. Remove the light assembly.
5. Install the electrical connector to the
replacement light assembly.
6. Reinstall the light assembly. Tighten the
screws.
Torque: 36 in-lbs (4 Nm)
7. Reinstall the rear body panel. Tighten the
screws.
Torque: 65 in-lbs (7 Nm)
Screws
Electrical Connector