HEIDENHAIN TNC 320 (340 55x-05) ISO programming - Manual (Page 450)

450
Comparison: Touch probe cycles in the Manual
Operation and El. Handwheel modes
Cycle TNC 320 iTNC 530
Touch-probe table for managing 3-D touch probes X –
Calibrating the effective length X X
Calibrating the effective radius X X
Measuring a basic rotation using a line X X
Setting the datum in any axis X X
Setting a corner as datum X X
Setting a circle center as datum X X
Setting a center line as datum – X
Measuring a basic rotation using two holes/cylindrical studs – X
Setting the datum using four holes/cylindrical studs – X
Setting the circle center using three holes/cylindrical studs – X
Support of mechanical touch probes by manually capturing the current position By soft key By hard key
Writing measured values in preset table X X
Writing measured values in datum tables X X