HEIDENHAIN iTNC 530 (340 49x-05) Cycle programming - Manual (Page 242)

242 Canned Cycles: Multipass Milling
1
0
.1 F
undamentals
10.1 Fundamentals
Overview
The TNC offers four cycles for machining surfaces with the following
characteristics:
„ Created with a CAD/CAM system
„ Flat, rectangular surfaces
„ Flat, oblique-angled surfaces
„ Surfaces that are inclined in any way
„ Twisted surfaces
Cycle Soft key Page
60 RUN 3-D DATA
For multipass milling of 3-D data in
several infeeds Page 243
230 MULTIPASS MILLING
For flat rectangular surfaces Page 245
231 RULED SURFACE
For oblique, inclined or twisted surfaces Page 247
232 FACE MILLING
For level rectangular surfaces, with
indicated oversizes and multiple infeeds Page 251