HEIDENHAIN 530 (340 49x-07) Cycle programming - Manual (Page 491)

HEIDENHAIN iTNC 530 491
1
8
.4 MEA
S
URE KINEMA
TICS (Cy
c
le
451, DIN/ISO: G451; Option)
Log function
After running Cycle 451, the TNC creates a measuring log
(TCHPR451.TXT) containing the following information:
„ Creation date and time of the log
„ Path of the NC program from which the cycle was run
„ Mode used (0=Check/1=Optimize position/2=Optimize pose)
„ Active kinematic number
„ Entered calibration sphere radius
„ For each measured rotary axis:
„ Starting angle
„ End angle
„ Angle of incidence
„ Number of measuring points
„ Dispersion (standard deviation)
„ Maximum error
„ Angular error
„ Ascertained backlash
„ Averaged positioning error
„ Measuring circle radius
„ Compensation values in all axes (preset shift)
„ Evaluation of measuring points
„ Measurement uncertainty of rotary axes