HEIDENHAIN iTNC 530 (60642x-04) Cycle programming - Manual (Page 439)

HEIDENHAIN iTNC 530 439
16.8 MEA
S
URE RECT
ANGLE OUTSIDE (Cy
c
le 424, DIN/ISO:
G424)
 Measuring log Q281: Definition of whether the TNC is
to create a measuring log:
0: No measuring log
1: Create measuring log: By default, the TNC saves
the log file TCHPR424.TXT in the directory in which
your measuring program is stored.
2: Interrupt program run and display the measuring
log on the screen. Resume program run with NC
Start.
 PGM stop if tolerance error Q309: Definition of
whether in the event of a violation of tolerance limits
the TNC is to interrupt program run and output an
error message:
0: Do not interrupt program run, no error message
1: Interrupt program run, output an error message
 Tool for monitoring Q330: Definition of whether the
TNC is to monitor the tool (siehe „Tool monitoring”
auf Seite 416). Input range: 0 to 32767.9, alternatively
tool name with max. 16 characters:
0: Monitoring not active
>0: Tool number in the tool table TOOL.T
Beispiel: NC blocks
5 TCH PROBE 424 MEAS. RECTAN. OUTS.
Q273=+50 ;CENTER IN 1ST AXIS
Q274=+50 ;CENTER IN 2ND AXIS
Q282=75 ;1ST SIDE LENGTH
Q283=35 ;2ND SIDE LENGTH
Q261=-5 ;MEASURING HEIGHT
Q320=0 ;SET-UP CLEARANCE
Q260=+20 ;CLEARANCE HEIGHT
Q301=0 ;MOVE TO CLEARANCE
Q284=75.1 ;MAX. LIMIT 1ST SIDE
Q285=74.9 ;MIN. LIMIT 1ST SIDE
Q286=35 ;MAX. LIMIT 2ND SIDE
Q287=34.95 ;MIN. LIMIT 2ND SIDE
Q279=0.1 ;TOLERANCE 1ST CENTER
Q280=0.1 ;TOLERANCE 2ND CENTER
Q281=1 ;MEASURING LOG
Q309=0 ;PGM STOP IF ERROR
Q330=0 ;TOOL