HEIDENHAIN iTNC 530 (60642x-04) Cycle programming - Manual (Page 90)

90 Fixed Cycles: Drilling
3.8 UNIVER
SAL PECKING
(Cy
c
le
205, DIN/ISO:
G205)
Please note while programming:
Program a positioning block for the starting point (hole
center) in the working plane with radius compensation R0.
The algebraic sign for the cycle parameter DEPTH
determines the working direction. If you program
DEPTH=0, the cycle will not be executed.
If you enter different advanced stop distances for Q258 and
Q259
, the TNC will change the advanced stop distances
between the first and last plunging depths at the same
rate.
If you use Q379 to enter a deepened starting point, the TNC
merely changes the starting point of the infeed
movement. Retraction movements are not changed by
the TNC, therefore they are calculated with respect to the
coordinate of the workpiece surface.
Danger of collision!
Enter in MP7441 bit 2 whether the TNC should output an
error message (bit 2=1) or not (bit 2=0) if a positive depth
is entered.
Keep in mind that the TNC reverses the calculation for pre-
positioning when a positive depth is entered. This
means that the tool moves at rapid traverse in the tool axis
to set-up clearance below the workpiece surface!
Enter in MP7441 bit 0 whether the TNC should output an
error message (bit 0=0) or not (bit 0=1) if spindle rotation
is not active when the cycle is called. The function also
needs to be adapted by your machine manufacturer.