HEIDENHAIN TNC 620 (340 56x-03) - Manual (Page 10)

10
New F
u
nctions of Sof
tw
a
re
340
56x
-02
New Functions of Software
340 56x-02
„ The PLANE function for flexible definition of a tilted working plane
was introduced (see "The PLANE Function: Tilting the Working
Plane (Software Option 1)" on page 343).
„ The context-sensitive help system TNCguide was introduced (see
"Calling the TNCguide" on page 129).
„ The FUNCTION PARAX function for defining the behavior of the parallel
axes U, V and W was introduced (see "Working with the Parallel
Axes U, V and W" on page 327).
„ The conversational languages Estonian, Korean, Latvian,
Norwegian, Romanian, Slovak and Turkish were introduced (see
"Parameter list" on page 486).
„ Individual characters can now be deleted by using the backspace
key (see "Coordinate axes and numbers: Entering and editing" on
page 3).
„ The PATTERN DEF function for defining point patterns was introduced
(see User's Manual for Cycles).
„ The SEL PATTERN function makes it possible to select point tables
(see User's Manual for Cycles).
„ With the CYCL CALL PAT function, cycles can now be run in
connection with point tables (see User's Manual for Cycles).
„ The DECLARE CONTOUR function can now also define the depth of the
contour (see User's Manual for Cycles).
„ New Cycle 241 for Single-Lip Deep-Hole Drilling was introduced
(see User’s Manual for Cycles).
„ The new fixed cycles 251 to 257 were introduced for milling
pockets, studs and slots (see User's Manual for Cycles).
„ Touch probe cycle 416 (Datum on Circle Center) was expanded by
parameter Q320 (safety clearance) (see User's Manual for Cycles).
„ Touch probe cycles 412, 413, 421 and 422: Additional parameter
Q365 (type of traverse) (see User's Manual for Cycles).
„ Touch probe cycle 425 (Measure Slot) was expanded by parameters
Q301 (Move to clearance height) and Q320 (setup clearance) (see
User's Manual for Cycles).
„ Touch probe cycles 408 to 419: The TNC now also writes to line 0
of the preset table when the display value is set (see User's Manual
for Cycles).
„ Datum tables can now also be selected in the machine operating
modes Program Run, Full Sequence and Program Run, Single Block
(STATUS M).
„ The definition of feed rates in fixed cycles can now also include FU
and FZ values (see User's Manual for Cycles).