Eagle Pump & Compressor A100 ANSI PUMPS - Manual (Page 5)

5
PRIOR TO COUPLING DRIVER TO PUMP, ROTATION OF
DRIVER SHOULD BE CHECKED! Serious damage can result
if pump is rotated in wrong direction. Once motor rotation
is checked, connect coupling, following the manufacturer’s
instructions. If a coupling guard is furnished with the unit,
ensure that it is securely fastened in place.
II-F. Stufng Box
1. Packing:
If the pumpage is dirty or hot, it is not suitable to lubricate the
packing. An external source must be utilized, unless the bypass
is equipped with proper separator, filter, and/or cooling system.
This must be piped into the lantern ring connection, also (refer
to packing recommendations).
2. Mechanical Seals:
When mechanical seals are supplied, they are installed and
adjusted at the factory. They must not run dry or in abrasives.
Connect recirculation, flush and/or cooling lines as required,
following instructions on the seal print supplied for the unit.
III-A. Startup
1. Check List
a. Lubrication—Pump bearings are normally oil lubricated.
(THE BEARINGS ARE NOT LUBRICATED AT THE
FACTORY.) These pumps are supplied with an oiler which
maintains a constant oil level in the bearing frame. Locate
oiler as shown on the outline drawings supplied for the
unit. See Fig. 6 for correct adjustment of oiler.
SECTION III—OPERATION
Figure 3
Figure 5
Figure 6
Figure 4
R O TAT E
THIS HUB
Figure 4
OIL LEVEL OIL LEVEL
SET SCREW
WEDGES