Yaskawa 1000 Series Drive Option - Profibus-DP Technical Manual - Manual (Page 7)

3 Receiving
YASKAWA ELECTRIC SIEP C730600 42B 1000-Series Option SI-P3 Technical Manual 7
3 Receiving
Please perform the following tasks upon receiving the option:
• Inspect the option for damage. Contact the shipper immediately if the option appears damaged upon receipt.
• Verify receipt of the correct model by checking the model number printed on the option nameplate
(Refer to Figure 1 on page 8 ).
• Contact your supplier if you have received the wrong model or the option does not function properly.
‹ Contents and Packaging
Table 2 Contents of Package
‹ Tools Required for Installation
• A Phillips screwdriver (M3 metric / #1, #2 U.S. standard size) is required to install the option.
• A pair of diagonal cutting pliers.
• A small file or medium-grit sandpaper.
Note: Tools required to prepare option cables for wiring are not listed in this manual.
Description: Option Ground Wire Screws (M3) LED Label Installation Manual
-
Quantity: 1 1 3 1 1
ERR
BF
RUN
COMM
MANUAL