Yaskawa YASNAC PC NC PLC Programming Manual - Manual (Page 152)

8 - 4
YASNAC PCNC PLC Programming Manual Chapter 8: Online Editing
• ENDP
ì The message data area is cleated.
ö The conversion data area is cleated.
ú The symbol data area is cleated.
8.1.1 Creating a Sequence Program by Modifying the Existing Sequence Program
PCNC:Set the RSW (rotary switch) to “4” on the NC unit.
The operation steps to be followed when creating a sequence program by modifying the
existing sequence program are described below.
Turn the power ON in the sequence program development mode.
Carry out editing operation
Error?
Select the run mode for the sequence program.
Error?
Run and check the sequence program.
Bugs?
YES
YES
YES
Completion of sequence program creation.
NO
NO
NO