Yaskawa YASNAC PC NC PLC Programming Manual - Manual (Page 156)

8 - 8
YASNAC PCNC PLC Programming Manual Chapter 8: Online Editing
8.3.3 NET SEL (Net Selection) Function
The function displays only the selected nets. This function is used when the nets to be referenced
are separated from each other so that displaying them on one display page is impossible.
This function is executed in the following procedure.
€ On the sequence ladder display screen, press the ENTER key when the net number to be
selected is displayed.
ó The selection symbol is displayed and the net is set in the selected status.
Selection is possible for up to ten nets. If an attempt is made to select the net exceeding
this limit, a warning message is displayed.
“SELECTION OVER!”
Fig. 8.2 Ladder Diagram Display Screen
ì Press the [
NET SEL ] function soft-key .
While the selected nets are collected, the message “COLLECTING” is displayed.
After the completion of met selection, the ladder of the collected nets is displayed and
the message is cleared.
ö Press the [
NET SEL ] function soft-key once again, and the screen returns to the
normal sequence ladder display screen.
The selected status of the nets is cleared when the power is turned OFF.