Yaskawa YASNAC PC NC PLC Programming Manual - Manual (Page 182)

8 - 34
YASNAC PCNC PLC Programming Manual Chapter 8: Online Editing
8.5 Table Edit Function
The table data editor is provided to edit the table data.
The data of the following three tables can be edited.
• Message table
• Conversion table
• Symbol table
8.5.1 Editing the Data in Conversion Table
The conversion data that has been set by using the pseudo instruction “CONVERSION”
can be edited.
The data can be edited in units of bytes. The data for which word or double-word designation
has been made in the conversion table of the source program are also displayed in units of words
in this screen.
Conversion data are set in hexadecimal.
The conversion data numbers are indicated below:
N9000 - N9007 256bytes
N9008 - N9023 128 bytes
“FFH” is displayed for undefined conversion data.
Fig. 8.20 Conversion Data Edit Screen