iSys V8.5e Thermal Printer - Manual (Page 46)

46
6.2 MAINTENANCE GUIDELINES
In order to minimize the complexity of troubleshooting and repairs, the V8.5e plotter is composed, wherever
possible, of field replaceable units (FRUs). The Imaging Systems Group Inc. does not recommend troubleshooting
at a component level, but rather to the
level of these FRUs. This chapter and the troubleshooting chapter of this manual follows this approach, resulting
in faster and easier repairs. Replacing or repairing FRUs, rather than smaller components, minimizes downtime and
simplifies procedures.
Use caution while troubleshooting the V8.5e. Turn the power off and unplug the power cord to prevent
electrical shock.
Seien Sie bei der Fehlerbehebung am V8.5e vorsichtig. Schalten Sie den Strom ab und ziehen Sie den
Netzstecker, um Stromschläge zuvermeiden.
6.3 REGULAR MAINTENANCE
The V8.5e thermal plotter is engineered to require minimal preventative maintenance. If the thermal printhead and
platen roller are cleaned regularly, and the plotter is kept free of debris, extra maintenance should rarely be
required.
This minimal preventative maintenance is the customers responsibility. Damage to the plotter that has in The
Imaging System Group’s opinion resulted from neglect or misuse will not be covered
under warranty.
CAUTION: No parts of the V8.5e require lubrication. All bearings are sealed and self-lubricating. These bearings
must be replaced in pairs if one fails by authorized repair depot.
VORSICHT: Kein Teil des V8.5e erfordert Schmierung. Alle Kugellager sind geschlossen und selbstschmierend.
Diese Lager dürfen nur paarweise durch eine autorisierte Servicewerkstatt ausgetauscht werden, falls eines defekt
wird.