Lanner LEC-3012 - Manual (Page 20)

20
Introduction
Chapter 4
Embedded and Industrial Computing
Installing a CompactFlash Card
LEC-3012 provides one CompactFlash slot. Follow the
procedures bellow to install a CompactFlash card.
Unscrew the thumbscrew on the CF slot to take out 1.
the front cover.
Align CompactFlash and the card slot with the arrow
2.
on the CompactFlash pointing toward the connector.
Insert the CompactFlash into the connector.
3.
Close the cover and fasten it with the thumbscrew to 4.
the slot.
Note: The device has an error proof design so that
the card will not be inserted if it is in the wrong
orientation. You should insert the CF card with the
arrow on the CompactFlash facing up and pointing
toward the connector.
1
2
Installing the Hard Disk
The system can accommodate one Serial-ATA disk. Follow
these steps to install a hard disk into the LEC-3012):
Place hard disk on the hard disk tray of the cover and 1.
align the holes of the hard disk with the mounting
holes on the tray.
Fix the hard disk on the hard disk tray by using 4
2.
mounting screws
Connect the Serial-ATA power and drive cables to the
3.
hard disk’s power and drive connectors respectively.
Plug the Serial-ATA cable to the Serial-ATA Connector
4.
on the main board.
Put the hard disk tray with the installed hard disk back
5.
to the system and secure it to the system case with the
mounting screws.