Bang & Olufsen BeoSound 5 User Guide - Manual (Page 31)

31
Change source names
For easier access to the N.MUSIC source
by remote control, you can set the
system to activate the N.MUSIC source
via the A.MEM button.
> Use the pointer to highlight MODE.
> Turn the wheel to select SETTINGS and
press GO.
> Use the pointer to highlight ROLES.
> Turn the wheel to select either CD,
A.MEM or N.MUSIC and press GO.
> Make changes for the N.RADIO source as
well, if you want.
> Press GO to store.
NOTE! When you change the source name
to CD or A.MEM, it is also changed in the
display of the music system, and you must
replace N.MUSIC, when mentioned in the
operation sequences, with CD or A.MEM.
Also N.RADIO is replaced by RADIO, if you
make a change for this source as well.
Source naming
The source name determines which Beo4
button activates the source in question and
also which source name is shown in the
BeoSound 5 display.
If the optional CD Ripping Device is
connected, the three source names are
interchanged, if you switch one of them.
This means that if you change N.MUSIC to
CD, the CD Ripping Device is activated by
selecting N.MUSIC.
Delay
To ensure that a connected television is
ready to play music from the music
system, a delay can be set. This only
applies when the music system is set for
Option 0.
> Use the pointer to highlight MODE.
> Turn the wheel to select SETTINGS.
> Press twice and press GO.
> Use the pointer to highlight ROLES.
> Turn the wheel to select DELAY and press
GO.
> Make settings for the necessary delay.
> Press GO to store.
>> The Roles menu