Logitek Electronic Systems AE-32 Audio Engine - Manual (Page 34)

Release Notes
Logitek Audio Engine Reference Manual 32
SHARC Attack (Artisan version)
Module Date Version Notes
SHARC Attack (Artisan) February 2005 1.33  Fixed problem that caused audio shift on chan 29 & 30.
 Improvements to buffer handling.
 Added support for Lipsync Delay beyond Fader 8.
SHARC Attack (Artisan) March 2007 1.34  Fixed Input Trim interfering with Pan/Balance.
SHARC Attack (Artisan) March 2007 1.35  Fixed Trim problem for too small Fader/Aux level table.
SHARC Attack (Artisan) May 2007 1.36  Added support for Faders 31 & 32.
SHARC Attack (Artisan) May 2007 1.37  Fixed bug that caused Master2 to corrupt Master1 Mix-.
SHARC Attack (Artisan) December 2008 1.38.7  Fixed mono channels 6dB low in M1 stereo and mono mixes.
Sharc Attack (Artisan) February 2009 1.38.8  Fixed missing center channel in Mix- from M1 and M2.
 Fixed problem minusing mono sources from Mix- busses.
AE-C2
Module Date Version Notes
AE-C2 July 2002 3.01  First v3 release.
 Store effect and mix minus values in nvSRAM.
 Restored support for 24 busses.
 Hardware change required.
AE-C2 July 2002 3.01  Don’t send meter commands to ports 1, 2, 3 if transmit buffers
are almost full.
 Timer based TDM backplane format.
AE-C2 August 2002 3.01  Updated mic unmuting to use new nvRAM format.
AE-C2 September 2002 3.03  Improvements to Read/Write driver (U44).
 Hardware change required.
AE-C2 September 2002 3.04  Handles 110 outputs from NetA.
AE-C2 October 2002 3.05  Changed backplane timing so that IO8D don’t overlap
timeslots.
AE-C2 October 2002 3.06  Added support for 44.1k and 32k sampling rates.
 Switched to UK meter lookup if required.
AE-C2 November 2002 3.07  Fixed error sending mix minus and feature word to DSP.
 Fixed nvRAM storage problem for pan.
 Network channel table added to database.
 Updated tables to leave more space between IO8D cards.
 Prevented channel mapper from executing if slot H does not
contain a NetA card.
AE-C2 December 2002 3.08  Fixed problem with failure to start if only one DSP specified.
 ROC5 Note: Mix minus 1-5 commands will not be sent to a
ROC5 on startup because it starts at fader 6.
AE-C2 March 2003 3.09  Stopped host boot to SHARCAttack DSP.
 Fixed problem that could cause dropped commands to surface.
 Disabled soft reset temporarily.
 Added slave fader cmd.
AE-C2 April 2003 3.10  Auto switches Port 3 between ROC5 and Remora addressing.
 Enabled Soft Reset on unmapped Ports 1, 2 and 3.
 Send Table1 and Table7 procedure calls from command
library.
 Added new surface updating system to Ports 2 and 3.
 Improvements to prevent lockup with blank screen at startup.
AE-C2 April 2003 3.11  Fixed possible jammed startup when nvSRAM is corrupted.
 Added 0.5 sec delay between power up and DSP card reset to
allow for slower DSP card start.
 Added soft reset when both Red and Green power supply
buttons are pressed.
AE-C2 May 2003 3.12  Removed procedure calls to prevent command processor