Logitek Electronic Systems AE-32 Audio Engine - Manual (Page 37)

Release Notes
Logitek Audio Engine Reference Manual 35
AE-C6 August 2006 3.69  Fixed bug in v3.68 that prevented Port4 transmitting.
AE-C6 August 2006 3.70  Automatically perform a second Quick Reset after power-up or
Quick Reset.
AE-C6 September 2006 3.71  Fixed problem in v3.68 that can cause LCD to erase bottom
row.
AE-C6 September 2006 3.72  Fixed bug that prevents Supervisor status setting.
 Fixed bug that prevented C2 meter data being stored at the
correct device numbers.
 Added flag to turn off C1 Aux Meters that flood Supervisor.
AE-C6 September 2006 3.73  Added the ability to autofade up to 10 channels at once.
AE-C6 January 2007 3.74  Increased the number of simultaneous autofades to 30.
AE-C6 June 2007 3.75  Removed test code that forced surface type = Artisan.
 Updated variables to support 5.1 routing from v3.93.
 Disable 5-second auto reset when executing “Config Not
Loaded” reset.
AE-C6 (Artisan)
Module Date Version Notes
AE-C6 Artisan April 2006 3.66  Special test version for Artisan surface.
AE-C6 Artisan June 2006 3.90  Address tables modified to supply 15 meter addresses to Port 1.
AE-C6 Artisan October 2006 3.91  Adjust address tables for Std3_Art.dsp.
 Added 4 nvRAM words for AuxA & AuxB operation.
 Added AE type 51 & 52 (dec) for aux state control.
 Added AC type 1 & 2 for aux gain control.
AE-C6 Artisan December 2006 3.92  Adjusted address tables for Std3_art.dsp.
 Reflected PFL commands between Left DSP to Right DSP.
 Reflected CNG commands between Left DSP and Right DSP.
AE-C6 Artisan February 2007 3.93  Added 6 channel routing.
 Autofade from v3.74 included.
AE-C6 Artisan March 2007 3.94  Fixed a bug that shifted the Network received channels by 1.
AE-C6 Artisan April 2007 3.95  Fixed a bug at PCSOL: system can hang if RouteLink table has
errors.
 Added support for AuxA & AuxB faders to autofade command.
AE-C6 Artisan April 2007 3.96  Added support for Faders 31 & 32.
AE-C6 Artisan July 2008 3.96.1  Raised Port1 & Port2 transmit buffer meter command cutoff to
prevent meter command from being dropped during normal
operation.
 Installed switch on device33 bus3 to turn off A1 commands for
large surfaces to provide additional protection from COM Port
overload.