Logitek Electronic Systems AE-32 Audio Engine - Manual (Page 36)

Release Notes
Logitek Audio Engine Reference Manual 34
AE-C2 January 2006 3.25  Added support for aux C1 commands.
 Send UK settings to surfaces.
 Changed so that external sync must be stable for 5 secs before
switching to external sync.
AE-C2 June 2006 3.26  Send system table info to Slot K DSP before sending mix minus
setting to Port3. This fixes the problem of Port3 mix minus not
working after a full or quick reset.
AE-C2 June 2006 3.27  Fixed problem that enables additions to Table1 copy sent to
surfaces after a soft reset. The prior Table1 was being sent to
surfaces.
AE-C2 November 2007 3.28  Stopped Device1 from echoing commands from Supervisor
back to Supervisor.
AE-C6
Module Date Version Notes
AE-C6 May 2004 3.53  First v3 release.
AE-C6 September 2004 3.54  Added delay parameters to nvSRAM state.
 Fixed problems with transmit buffer on Port3.
 Added Cue audio to Port3.
 Fixed problems with using RTE-3 and RTE-XY on Ports 4-6.
AE-C6 September 2004 3.55  Added text message to Supervisor for External Sync On/Off.
 Fixed problem with missing input meters on Port3.
 Fixed non-functional Mix- on Port3.
AE-C6 November 2004 3.56  Changed intercharacter receive timeout on Slots G & H from 4
to 75 mSec to solve problem of AEConfig hanging on uploads
to Engine.
AE-C6 January 2005 3.57  Stop commands on unmapped ports being echoed back to
same port.
AE-C6 March 2005 3.58  Added support for 16-character names (Table9)
AE-C6 May 2005 3.59  Send delay times from Port2 Route1 & 2 to surface.
AE-C6 May 2005 3.60  Improvements to B4 command filter.
AE-C6 September 2005 3.61  Added delay status flags to busses 24-26.
AE-C6 October 2005 3.62  Send Independent Bus Switch, Aux Fader & International
Setting to Port1 & 2 at the end of the Port Settings command.
AE-C6 November 2005 3.63  Added support for C1 meter commands from SHARCAttack.
 Modified address maps to send aux bus meters to surfaces.
AE-C6 January 2006 3.64  Modified External Sync to require 5 sec of stable sync before
switching to external.
 Added unroute command (B4 with source device = 0000).
 Made Soft Reset compare old & new device tables, unroute
deleted devices and install default route for new destination
devices.
 If SHARCAttack meters stop, assume card lockup and reboot
DSP & perform Soft Reset.
AE-C6 February 2006 3.65  Fixed problem with SHARCAttack that prevented init
commands from executing.
 Prevented Mosaic timer reset cmd (AE type 40) from causing
click in Audio.
AE-C6 April 2006 3.66  Special test version for Artisan.
AE-C6 June 2006 3.67  Fixed problem that scrambled additions to Table1 copy sent to
surfaces after a Soft Reset. Prior table was being sent to surface.
AE-C6 July 2006 3.68  Timing improvements..
 Synchronize card reset to prevent DSP cards jamming.
 Sent missing type 1 85 command (missing lock, au and bus
control) to Port2 surface.