Enterasys Networks 9033348-02 - Manual (Page 30)

Overview of Connecting Cables to the Access Point
2-2 Access Point Placement and Configuration
Overview of Connecting Cables to the Access Point
Before cabling the Access Point, you should install the Access Point to a wall or ceiling.
For detailed hardware installation procedures, see the RoamAbout Access Point 2000
Hardware Installation Guide.
Figure 2-1 provides you with an illustration of the steps
listed in the following procedure.
1. Insert the PC Card into the Access Point. Refer to the RoamAbout 802.11 PC Card
Installation Guide for Regulatory and Installation information before installing the PC
Card.
Figure 2-1: Access Point 2000 Installation Overview
www
.cabletron.com/wireless
1
2
MAC ADD
SN
TUV
S2
S1
To Power Outlet
Insert Ethernet
Cable from
Network
3
5
6
2
To Lightning
Protector
4
1
7
MAC
Address
8