Enterasys Networks 9033348-02 - Manual (Page 32)

Overview of the Access Point Configuration
2-4 Access Point Placement and Configuration
Overview of the Access Point Configuration
The following provides an overview of configuring the Access Point with the Access Point
Manager. For detailed procedures, see the RoamAbout 802.11 Wireless Networking Guide
or click the Help button in the Access Point Manager. Before you begin, you need the
following:
•
A valid unused IP address for each Access Point from the network administrator.
•
The wireless MAC address of both Access Points. The wireless MAC address is NOT
the same as the wired MAC address printed on the Access Point label. Perform one of
the following to see the wireless MAC address:
— If both Access Points are currently managed by the AP Manager, select each
Access Point from the Managed List field and click the Hardware button.
— Using the Access Point console port at each Access Point, choose Show Current
Settings from the RoamAbout Access Point Installation Menu.
— Check the back of the PC Card used in the Access Points. The MAC address of
the PC Card is the Access Point’s wireless MAC address.
1. Install the Access Point Manager on a Windows 95, 98, 2000, Millennium, or NT
(V4.0 or later), computer that is located on the same wired network as the Access
Point.
2. Open the Access Point Manager (Start button, Programs
→
RoamAbout
→
RoamAbout Access Point Manager).
3. Click the Setup/Add New Access Point button ( Figure 2-2 ). When prompted, click
Yes to load an IP address.
4. Enter the Access Point’s wired MAC address.
5. Enter the unused IP address. Click OK. You may need to wait a few minutes for the
address to load.
6. In the Identification dialog box, enter a unique system name that identifies the Access
Point then click OK.
7. In the Station Name field, enter a unique name for the Access Point. The station name
is displayed when running the Link test. Click OK.
8. In the Wireless Parameters dialog box, select a channel for the Access Points. All
Access Points in a LAN-to-LAN configuration must use the same channel.
9. Click the Advanced button.