Eagle Electronics EVR-150 - Manual (Page 26)

26 EAGLE - EVR-150 Installation and Operation Instructions
Section 3 - Radio Setup Menu (RADIO SETUP)
3-1 Radio Setup Menu (RADIO SETUP)
Sections 1-3 and 1-4 explain how to navigate around the menu and enter, save and
change data.
3-2 Channel Names (CH NAME)
The channel charts are listed in Appendix C with their default name tags. CH NAME gives you
the option to edit or delete the channel name tags displayed on the screen.
1. Select RADIO SETUP, then CH NAME.
2. Use + or - to step through the channels with their name tags until you see the channel
name tag you want to change, then press ENT. In this example, the channel name
TELEPHONE associated with channel 01 is being changed to PHONE1.
3. Select EDIT and press ENT to edit the existing name tag. Input the new name over the
existing name. It can be a maximum of 12 characters.
To delete the channel name, select DELETE and press ENT.
CH NAME
RING VOLUME
BEEP VOLUME
INT SPEAKER
WATCH MODE
WX ALERT
COM PORT
Edit or delete channel names.
See Section 3-2.
(Selects if the WX Alert scanning mode is ON (on) or OFF (off ).
See section 3-6.
Selects the operation of Dual or Tri watch scanning.
See section 3-5.
Switch ON/OFF (on/off ) the radio’s internal speakers.
See section 3-4.
Select NMEA protocol for communications between the VHF radio
and any other instruments. See section 3-7.
Set the volume level of the beeps.
See section 3-3.
Set the volume level of the incoming call notification beeps.
See section 3-3.
RADIO SETUP
>CH NAME
RING VOLUME
BEEP VOLUME
CH NAME
TELEPHONE
01
TELEPHONE
>EDIT
DELETE
EDIT CH NAME
TELEPHONE
EDIT CH NAME
PHONE1
>YES
NO