Eagle Electronics EVR-150 - Manual (Page 29)

29 EAGLE - EVR-150 Installation and Operation Instructions
4-1 DSC Setup - Menu Options
The following options are available:
Sections 1-3 and 1-4 explain how to navigate around the menu and enter, save and
change data.
4-2 Enter Your USER MMSI (USER MMSID)
This is a once-only operation. You must enter your user MMSI before you can access the DSC
functions.
You can display and read your user MMSI at any time, but you get only one opportunity to
enter your user MMSI.
1. Select DSC SETUP, then USER MMSID.
2. If this is the first time that you are entering your user MMSI, a dashed line appears.
Enter your user MMSI along the dashed line. Press ENT to confirm each correct entry and
to move to the next digit.
If you make an error, press - until < appears, then press ENT to backup and correct the
entry.
3. Press ENT to store your user MMSI.
Section 4 - DSC Setup Menu (DSC SETUP)
A valid USER MMSI must be entered into this radio before these DSC functions can be
used. See below for instruction to Enter Your USER MMSI.
USER MMSID
GROUP SETUP
INDIV REPLY
DSC FUNC
LL REPLY
DSC SETUP
>USER MMSID
GROUP SETUP
INDIV REPLY
USER MMSID
INPUT AGAIN
–––––––––
INPUT USER
MMSID
–––––––––
187654321
MMSID
>STORE
CANCEL
Enter your user MMSI. See section 4-2. (If you do not have a user MMSI,
see Appendix D.)
Enter or change the name and/or details of a group.
See section 4-3.
Select the type of response to an LL polling request.
See section 4-6.
Turn the DSC operation ON/OFF (on/off ).
See section 4-5.
Choose an automatic or manual response to calls. See section 4-4.
!
WARNING