Eagle Electronics EVR-150 - Manual (Page 5)

5 EAGLE - EVR-150 Installation and Operation Instructions
This Eagle radio is designed to generate a digital maritime distress call to facilitate search and
rescue. To be effective as a safety device, this radio must be used only within the geographic
range of a shore-based VHF marine Channel 70 distress and safety watch system. The
geographic range may vary but under normal conditions is approximately 20 nautical miles.
Installation
Installation Options
There are two ways to install the radio. You can choose:
•
a deck or overhead mounted gimbal installation. The reversible mounting gimbal is fixed to
to a suitable site and the radio is placed into it. The radio can be removed for storage and
the viewing angle can be adjusted.
• a recessed installation. The radio is recessed into a cavity cut into a bulkhead. The radio
fixture is permanent and the viewing angle cannot be adjusted.
Location Requirements
Please check these BEFORE doing any cutting or drilling.
Whichever installation method you choose, ensure that the chosen location:
• is at least 3' (1 m) from the antenna
• allows easy connection to (at least) a 10 Amp fused 13.6 V DC electrical source and the
antenna
• is at least 1.5' (45 cms) from the compass to avoid creating magnetic deviation of the
compass during radio operation
• has a suitable space close by for installing the microphone bulkhead mount
• provides easy access to the controls on the front panel
• provides reasonable access to the wiring at the back of the radio
• provides enough room to fix the
DSC warning label
The VHF has a large LCD screen
with an optimum viewing angle
of approx. +/-20 deg. Ensure
the chosen location provides
a suitable view of the display.
Ideally, the user should be directly
in front of the display or no more
than +/-20 deg from the front of
the display.
Note: If unsure, temporarily power
up the radio and check for a
suitable location.
20˚
20˚
20˚
20˚
Side
Top