Eagle Electronics EHR-10 - Manual (Page 12)

EAGLE EHR-10 Operation Instructions 12
10. Scanning
Your radio comes with three scan options:
Normal Scan: If there are no channels in memory, the default is Normal Scan. In Normal Scan
mode, all channels in the channel bank set are scanned in sequence. After the last channel
number has been scanned, the cycle repeats.
Normal scan will automatically check for transmission on the channel being scanned. If a signal
is received, the scan stops on the channel and the “SCAN” icon (flashing) will appear on the LCD
display. If the signal is lost for five seconds or more, the radio resumes scanning.
Memory Scan: In Memory Scan mode, only the channels that have been saved in memory are
scanned in sequence. After the last saved channel number has been scanned, the cycle repeats.
Priority Scan: In Priority Scan mode, you can scan all channels while alternately scanning
Channel 16 to make sure that you don’t miss distress or emergency calls. The secondary priority
Channel 09 can be scanned only if entered as a MEM channel or in TRI-WATCH mode.
To activate scan modes:
1. Press SCAN key once when no channels are stored in memory to activate the Normal scan
function. The Scan icon will appear on the LCD display.
or...
2. Press SCAN key once when there is at least one channel in memory to activate the Memory
Scan function. The “M” (Memory Channel) and “SCAN” icons will appear on the LCD display.
or...
3. Press and hold SCAN key for 3 seconds to enter Priority Scan mode. The Priority Scan “P”
icon will appear on the LCD display just before the “SCAN” icon.
4. During any of the Scan modes, press the or (UP/DOWN) keys to change the scan
direction. Up key to scan the channel upward, Down key to scan the channel downward.
5. Press and release SCAN key to terminate Scan mode.
NOTE: During Scan mode, the WX/UIC, MEM, and DW/TRI Watch keys will not function and will
sound an error beep if pressed.
11. Using the WATCH Modes
This radio is equipped with two types of monitor modes: Dual Watch and Tri Watch.
Dual Watch monitors the current working channel and Channel 16 alternately.
To activate and terminate Dual Watch mode:
1. Press and release DW/TRI Watch key to activate the Dual Watch mode. The “DU” icon will
appear on the LCD display.
2. Press and release DW/TRI Watch key again to terminate Dual Watch mode and return to the
previous working channel.
or...
3. Press and hold DW/TRI Watch key for 3 seconds to terminate Dual Watch mode and enter into
Tri Watch mode. The “TRI” icon will appear on the LCD display.