Eagle Electronics EHR-10 - Manual (Page 7)

EAGLE EHR-10 Operation Instructions 7
Before Using your Radio
Before using your radio, you should make the following preparations:
Carefully inspect the package contents for: the radio, battery pack, antenna, AC/DC wall charger,
wrist strap, belt clip, and this manual (including product warranty).
1. Fully charge the Ni-MH battery pack for a minimum 14 - 16 hours and install it onto the radio.
2. Install the antenna onto the radio.
3. Install the belt clip onto the radio.
1. Charging and Installing the Ni-MH Battery Pack
Install the Ni-MH battery pack onto the radio:
Use a coin or screwdriver rotate the screw lock clockwise to lock the battery pack onto the radio.
CO
IN
1. Plug in the AC/DC wall charger
- check the voltage is correct for
your wall charger.
2. Connect the charging wire into
the charging socket on the base
of the Ni-MH battery.
3. The red LED should light
indicating the charger is
connected. Charge for a
minimum 14 - 16 hours - do not
over-charge.