Eagle Electronics EHR-10 - Manual (Page 14)

EAGLE EHR-10 Operation Instructions 14
15. Resetting the Radio
You can reset any radio settings back to the factory default settings. Resetting the radio will:
Erase any channel(s) stored in memory.
Return to USA channels, if another channel bank is currently selected at the time of reset.
Return to USA channels, if another mode is currently selected at the time of reset.
Return power settings to their original state.
To reset the radio:
1. Turn the radio off by rotating PWR/VOL knob to the OFF position.
2. Simultaneously press and hold both SCAN and WX/UIC keys.
then...
3. Turn the radio on, continue to hold the SCAN and WX/UIC keys down for 3 seconds, then
release both keys.
Maintenance
To keep your radio functioning properly, follow these simple maintenance rules:
If your unit comes into contact with salt spray, simply wipe the affected surfaces with a soft
cloth dampened in fresh water.
When cleaning the LCD display protective lens, use a chamois and non-abrasive, mild cleaner.
Do not use a chemical glass cleaner on the lens as chemicals in the solution may cause
cracking in the lens.
Take care when cleaning dirt or grease on the lens to avoid scratching the lens.
Ensure the radio and battery are clean and dry after each use.