Eagle Electronics EHR-10 - Manual (Page 8)

EAGLE EHR-10 Operation Instructions 8
2. Installing the Antenna
You will need to make sure that the flexible antenna is attached to the radio. Ensure the radio is
turned OFF anytime that the antenna is not connected.
Installing the antenna:
Rotate the antenna clockwise to fasten securely to the threaded connector
on the top of the radio.
CAUTION
!
!
CAUTION
DANGER
WARNING
Remember to remove the radio after about 14-16 hours of charging time on the wall charger
to maximize battery life. Overcharging batteries may result in damage to both the battery
pack and radio.
Note: Do not operate the radio or press PTT key without an antenna installed.
3. Installing the Belt Clip
The belt clip supplied with your radio allows you to attach the radio to your belt. To install the belt
clip: slide the belt clip to the back of your radio, make sure that the fitting Groove is aligned.