Extron electronic Digital Video Transmitter and Receiver DVI 201 Rx - Manual (Page 10)

DVI 201 Tx/Rx • Installation and Operation
Installation and Operation, cont’d
2-4 DVI 201 Tx/Rx • Installation and Operation 2-5
Use 2 mounting holes on
opposite corners.
(2) 4-40 x 3/16"
Screws
1U Universal Rack Shelf
1/4 Rack Width
Front False
Faceplate
1/2 Rack Width
Front False
Faceplate
Both front false faceplates
use 2 screws.
Figure 2-2 — Mounting the transmitter or receiver
unit on a standard rack shelf
Under-furniture mounting
The unit can be mounted under a horizontal surface using an
optional MBU 125 under-desk mounting kit (part #70-077-01).
Mount the unit under a desk or table as follows:
1
. Secure the under-desk mounting brackets to the
transmitter or receiver with the four machine screws
provided in the mounting kit (figure 2-3).
2 . Hold the transmitter or receiver with attached brackets
against the underside of the desk or other furniture. Mark
the location of holes for screws on the desk.
3 . Drill 1/4" (6.4 mm) deep, 3/32" (2 mm) diameter pilot
holes in the table or desk at the marked screw locations
from the underside or inside (the concealed side) of the
furniture, where the transmitter or receiver will be located.
4 . Insert the four wood screws into the pilot holes. Fasten
each screw into the installation surface until just less than
1/4" of the screw head protrudes.
5 . Align the installed screws with the slots in the mounting
brackets, and place the transmitter or receiver against the
surface, with the screws through the bracket slots.
6 . Slide the transmitter or receiver slightly forward or back,
then tighten all four screws to fasten it in place.
Figure 2-3 — Under-desk mounting
Through-furniture mounting
The transmitter or receiver can be mounted through a desk or
other furniture using an optional Extron MBD 129 through-desk
mounting kit, part #70-077-02. Mount the transmitter or receiver
through a desk or table as follows (figure 2-4):
Figure 2-4 — Through-desk mounting