Extron electronic Digital Video Transmitter and Receiver DVI 201 Rx - Manual (Page 26)

DVI 201 Tx/Rx • Reference Information
Reference Information
DVI 201 Tx/Rx • Reference Information A-2 A-3
Specifications
N *Appropriate DVI-D to HDMI cables or adapters are required for
HDMI signal input/output.
Also, an optional Extron HDMI-to-DVI adapter is required in order to
transmit a CEC signal.
Video
Maximum data rate....................... 4.95 Gbps (1.65 Gbps per color)
Maximum pixel clock ................... 165 MHz
Resolution range ........................... 1920x1200 or 1080p @ 60 Hz
Formats ........................................... RGB and YCbCr digital video
Standards ........................................ DVI 1.0, HDMI 1.2
Video input and loop through— transmitters
Number/signal type ..................... 1 single link DVI-D (or HDMI*) input
1 single link DVI-D (or HDMI*) local loop-
through
Connectors
DVI 201 Tx/Rx................... 2 female DVI-D
DVI 201 A D Tx/Rx ........... 2 female DVI-I
Interconnection between transmitter and receiver
Connectors ..................................... (2) RJ-45 per unit for 2 CAT 5/5e/6/7
UTP (unshielded twisted parir) or STP
(shielded twisted pair) cables connecting
the transmitter and receiver
Termination standards.................. TIA/EIA T568A or T568B. Pin
configurations for each standard are
available in the manual's installation
chapter.
Signal transmission distance
1900x1200 or 1080p @ 60 Hz
CAT 5/5e/6/7 STP ... Up to 125' (38 m)
CAT 5/5e/6/7 UTP .. Up to 100' (30 m)
1024x768 or 720p/1080i @ 60 Hz
CAT 5/5e/6/7 UTP or STP
Up to 200' (60 m)
N The transmission distance varies greatly depending on the signal
resolution and on the type of cable, graphic card, and display used in the
system.
Video output— receivers
Number/signal type ..................... 1 single link DVI-D (or HDMI*)
Connectors
DVI 201 Tx/Rx................... 2 female DVI-D
DVI 201 A D Tx/Rx ........... 2 female DVI-I
Audio— DVI 201 A D Tx/Rx
Gain ................................................. Unbalanced output: 0 dB;
balanced output: +6 dB
Frequency response ...................... 20 Hz to 20 kHz, ±0.05 dB
THD + Noise .................................. 0.10% @ 1 kHz at nominal level
S/N .................................................. >85 dB at maximum output (unweighted)
Stereo channel separation ............ >86 dB @ 1 kHz
Audio input— DVI 201 A D Tx/Rx
Number/signal type
DVI 201 A D Tx .................. 1 stereo, unbalanced
DVI 201 A D Rx .................. 1 stereo, balanced/unbalanced
Connectors
DVI 201 A D Tx .................. (1) 3.5 mm mini audio jack (tip, ring, sleeve)
DVI 201 A D Rx .................. (1) 3.5 mm captive screw connector, 5 pole
Impedance
DVI 201 A D Tx .................. >10k ohms unbalanced, DC coupled
DVI 201 A D Rx .................. >18k ohms unbalanced, 14k ohms
balanced, DC coupled
Nominal level
DVI 201 A D Tx .................. -10 dBV (316 mVrms)
DVI 201 A D Rx .................. +4 dBu (1.23 Vrms)
Maximum level
DVI 201 A D Tx .................. +11 dBu, unbalanced at 1% THD+N
DVI 201 A D Rx .................. +16.8 dBu, unbalanced at 1% THD+N
N 0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ≈ 2 dBu
Audio output— DVI 201 A D Tx/Rx
Number/signal type
DVI 201 A D Tx .................. 1 stereo, balanced/unbalanced
DVI 201 A D Rx .................. 1 stereo, unbalanced
Connectors
DVI 201 A D Tx .................. (1) 3.5 mm captive screw connector, 5 pole
DVI 201 A D Rx .................. (1) 3.5 mm mini audio jack (tip, ring, sleeve)