Extron electronic Digital Video Transmitter and Receiver DVI 201 Rx - Manual (Page 15)

DVI 201 Tx/Rx • Installation and Operation
Installation and Operation, cont’d
2-14 DVI 201 Tx/Rx • Installation and Operation 2-15
Final installation
After testing and making any adjustments, do the following:
1
. At the power outlet, unplug the power supply.
N One power supply can power both the transmitter and
the receiver, so only one unit needs a power supply.
2 . Mount the transmitter or receiver into the wall box, and
attach the supplied Decora faceplate to the unit, as shown
in figure 2-11.
Wall opening
is flush with
edge of box.
Wall Box
Decora
Faceplate
Extron
DVI 201 A D
DV I
AU DIO IN
INP UT
Tx
Rx RS -23 2
PAS S T HR U
Figure 2-11 — Mounting the transmitter or receiver
3 . At the power outlet, reconnect the power supply. This
powers up both units.
Connections
Transmitter connections
The rack-mountable transmitter is in a quarter rack width
enclosure. The wall-mountable transmitter is in an enclosure
that can be mounted in UL standard wall boxes with Decora-
style face plates.
Figure 2-12 shows the front panel of both DVI 201 Tx models.
Figure 2-13 shows the rear panel of both models.
DVI 200 Tx Series
DVI INPUT LOCAL OUTPUT
DVI 201 Tx Front Panel
DVI 201 A D Tx Front Panel
INPUT
Rx
Tx
RS-232
PASS THRU
DVI
AUDIO L+R
4
2 1
1
3
Figure 2-12 — DVI 201 Tx front panel connectors