Casio EX-ZS50 - Manual (Page 22)

22
Quick Start Basics
To replace the memory card
Press the memory card and then release it.
This will cause it to pop out of the memory
card slot slightly. Pull the card out the rest of
the way and then insert another one.
• Never remove a card from the camera
while the back lamp is flashing green.
Doing so can cause the image save
operation to fail and even damage the
memory card.
Format a memory card on the camera before using it for the first time.
IMPORTANT!
• Formatting a memory card that already has snapshots or other files on it, will delete
its contents. Normally you do not need to format a memory card again. However, if
storing to a card has slowed down or if you notice any other abnormality, re-format
the card.
• Be sure to use the camera to format a memory card. Formatting a card on a
computer will result in a non-SD standard format, which can greatly slow down
processing time and cause compatibility, performance, and other problems.
• Before formatting a new Eye-Fi card to use it for the first time, copy the Eye-Fi
install files to your computer. Do this before formatting the card.
• Formatting a FlashAir card with the camera will delete files on the card that are
required for communication. For details about formatting, see the instructions that
come with the FlashAir card.
1.
Press [ON/OFF] (Power) to turn on the camera and then press [SET].
2.
Use [8] and [2] to select the “MENU” Control Panel option and then
press [SET] (page 33).
3.
Use [4] and [6] to select the “Set Up” tab.
4.
Use [8] and [2] to select “Format” and then press [6].
5.
Use [8] and [2] to select “Format” and then press [SET].
To format (initialize) a new memory card