Extron electronic Multi-Rate SDI Fiber Optic Transceiver FOX HD-SDI - Manual (Page 12)

FOX HD-SDI • Installation and Operation
Installation and Operation, cont’d
2-6 FOX HD-SDI • Installation and Operation 2-7
Through-desk mounting
The transceiver can be mounted through a desk or other
furniture using an optional Extron MBD 129 through-desk
mounting kit, part #70-077-02. Mount the transceiver through a
desk or table as follows (figure 2-4):
Figure 2-4 — Through-desk mounting
1 . Loosely attach the mounting brackets to the transceiver
using the four machine screws and washers supplied with
the mounting kit.
2 . Hold the transceiver against the inside of the surface
through which it will be mounted. Mark the four screw
holes on the inside of the surface to which you are
mounting the device.
3 . Drill four pilot holes, each 3/32" in diameter by 1/4" deep,
where you made marks.
4 . Using the provided four wood screws, secure the brackets
to the mounting surface.
5 . Slide the transceiver up and down in the mounting
brackets until the face of the transmitter or receiver is at
the desired height. Tighten the screws that secure the
brackets in place.
If the screws are inaccessible to a screwdriver:
a
. On the transceiver, mark the location of the brackets
relative to the screws.
b . Remove the transceiver from inside the furniture.
c . Tighten the screws.
d . Replace the unit inside the surface (step 4).
Projector mounting
The transceiver can be mounted on a projector bracket using
either of the following optional Extron projector mounting kits:
• PMK 300 projector mounting kit (part #70-374-01)
• PMK 350 low profile projector mounting kit
(part #70-563-02 [black] or part #70-563-03 [white])
PMK 300 mounting
Mount the transceiver to a PMK 300 bracket as follows:
1
. If necessary, remove the feet from the bottom of the
transceiver.
2 . Mount the transceiver to one of the bracket’s three
mounting plates using two of the supplied 4-40 x 3/16"
screws in opposite (diagonal) corners to secure the device
to the bracket. It can be vertically mounted facing either
up or down (figure 2-5).
N On the side mounting plates, the device is typically
mounted on the outside of the bracket.
On the front mounting plate, the device is typically
mounted on the inside of the bracket.
Extron
PMK 300
Multi-product Projector Mount Kit
U-Bolt
Front Mounting
Plate
Side Mounting
Plate
Extron
FOX 500 HDSDI
Transceiver
Power Supply
Bracket
Brace
Figure 2-5 — PMK 300 projector mounting a transceiver