Pmk 350 mounting, Pmk 350 mounting -9, Installation and operation, cont’d – Extron electronic Multi-Rate SDI Fiber Optic Transceiver FOX HD-SDI User Manual

Page 13

Advertising
background image

FOX HD-SDI • Installation and Operation

Installation and Operation, cont’d

2-8

FOX HD-SDI • Installation and Operation

2-9

3

.

Use the two included tie wraps to strap the power supply

to one of the brackets.

N

The PMK 300 has a hole in the bottom plate that allows the

projector pole to be inserted through the center of the plate

(figure 2-6), rather than outside of the plate (figure 2-5).

To install the PMK 300 in this configuration, slide the

bracket up from the bottom of the pole before the projector

is installed on the pole.

U-Bolt

Extron
PMK 300

Multi-product Projector
Mount Kit

Bracket
Brace

Figure 2-6 — Projector pole on the inside

4

.

Place the contoured bracket brace against the pole and

opposite the back plate. The pole should fit snugly into the

depression in the center of the bracket brace.

5

.

Place the U-bolt around the ceiling pole and insert the

two legs of the U-bolt through the round holes on the

contoured bracket brace and then through the slotted holes

on the bracket’s mounting plate.

N

The supplied U-bolt fits a typical (1.5" to 2.0" diameter)

ceiling pole.

6

.

Secure the bracket to the U-bolt with the included hex

nuts, washers, and lock washers. Tighten the hex nuts just

enough that they can be loosened by hand.

PMK 350 mounting

Mount the transceiver to a PMK 350 bracket as follows:
1

.

Remove the front and back plates from the PMK 350
(figure 2-7), using an Extron Tweeker or

a #2 Philips

screwdriver

. Retain the screws to reattach the plates when

you are finished.

Extron
PMK 350

Multi-product Projector
Mounting Kit

Cover Sheet

Front Plate

Rear Plate

U-bolt

L-shaped
Bracket

Contoured
Base

Extron

Power Supply

Extron
Quarter-rack
Sized Product

Figure 2-7 — PMK 350 projector mounting a
transceiver

2

.

If necessary, remove the feet from the bottom of the

receiver.

3

.

Secure the transceiver to one side of the mounting tray,

using two of the supplied 4-40 x 3/16" screws in opposite

(diagonal) corners.

4

.

Use the two included tie wraps to strap the power supply

to the bracket.

5

.

Place the PMK 350 around the projector ceiling mounting

pole (figure 2-7, above).

Advertising