Elmo L-1EX - Manual (Page 7)


English
BEFORE YOU USE
n Be sure to use the power cord applicable to your local power
specifications. If the product was sold in Japan, use the AC adapter sold
with the product with 100 VAC and 50 or 60 Hz.
n When storing the product, do not leave it under direct sunlight or by
heaters.
n It may be discolored, deformed, or damaged.
n Do not place this product in any humid, dusty, salt bearing wind, or
vibrating locations.
Use it under the following environmental conditions:
Temperature:
0°C - 40°C (32°F - 104°F)
Humidity: 30% - 85% (No condensation)
n Use a soft, dry cloth for cleaning.
Do not use any volatile solvent such as thinner or benzene.
n Do not point the camera lens directly at the sun. It may be damaged and
you may not be able to take pictures.
n Luminescent and Black Spots
There may be some pixels that do not properly operate due to
the use of CMOS Area Image Sensors made-up of many pixels.
Though luminescent or black spots may be found on the screen, it is a
phenomenon peculiar to the CMOS Area Image Sensors and is not a
malfunction.
n Follow the guidelines below to prevent the unit from dropping or
overturning.
• Use the product on a stable base, desk, or table. Do not place the
product on an unstable base or slanted location.
• Place or wire the unit to prevent the AC adapter cord or video cable
from pulling.
n Carry the product by holding the lower part of the main unit in both
hands. Never hold the product by the column or the camera head.