Ella Moss Automobile Parts - Manual (Page 32)

M:\Product Information\366-348\Instructions\366-348 MGB Fuel Injection Installation Instructions_Grant_2.doc
Installation Part 18 – Fuel Return Hose & Pump Power Wire
210. In the right rear corner of the trunk, directly below
the right reverse lamp assembly (130.1), there is a white
plastic plug in the floor of the trunk. (130.2)
366-348 Inst Fig 130
130.2
130.1
211.
Using a flat bladed screwdriver, gently pry the plug
out. Set it aside- we are going to use it later. We are
going to bring the fuel return line from the fuel injection
throttle body into the trunk through this hole, using the
plug as a grommet to protect the hose.
366-348 Inst Fig 132
212. Under the car:
213. Run the fuel return hose (that is connected to the
“OUT” nipple at the throttle body) and the red wire with
white stripe along the bottom of the car and back
towards the axle/battery box area, zip tying them to the
existing fuel hard line and brake lines. (Fig 132)
214.
When you get to the crossmembers, run the hose
and the wire over the crossmember rather than under.
(Fig 133) Remember not to pinch them if the
crossmember is removed and reinstalled later.
366-348 Inst Fig 133
215.
Route the fuel return line with the attached wire up
the side of the battery box (Fig 137), then over the axle
and to the hole in the trunk floor where we popped out
the plastic plug.
216.
Cut or punch a smooth hole in the plastic plug large
enough for the fuel hose. We have turned the plug into a
grommet, which will protect the fuel hose.
366-348 Inst Fig 137
Page 32 of 52