Ella Moss Automobile Parts - Manual (Page 35)

M:\Product Information\366-348\Instructions\366-348 MGB Fuel Injection Installation Instructions_Grant_2.doc
Part 19, continued
232.
Strip the insulation off the end of the red wire with
white stripe.
233.
Crimp the #8 ring terminal (supplied in the kit) onto
the wire. Secure it to the positive terminal on the fuel
pump, which is labeled “+”. (176.1)
234.
Find the 30” long piece of black wire, a ¼” ring
terminal and a #8 ring terminal supplied in the kit.
235.
Strip both ends of the wire. Crimp the ¼” ring
terminal to one end and the #8 ring terminal to the other.
236.
Secure the end of the black wire with the #8 ring
terminal to the negative terminal on the fuel pump, which
is labeled “-”. (176.3)
237.
Run the black wire up and over the axle to the
battery box on the passenger’s side (177.1). Locate the
¼” stud welded to the side of the battery box (177.2).
Remove the ¼” Nyloc nut from the stud using a 7/16”
socket. Slide the ¼” ring terminal over the stud and
replace the Nyloc nut. This is the ground connection for
the pump.
366-348 Inst Fig 176
176.1
176.2
176.3
366-348 Inst Fig 177
177.1
177.2
This completes part 19 of the installation.
Page 35 of 52