Ella Moss Automobile Parts User Manual
Page 9
M:\Product Information\366-348\Instructions\366-348 MGB Fuel Injection Installation Instructions_Grant_2.doc
17.1
366-348 Inst Fig 17
17.2
46. Cut the bracket to remove the 3.5” long section of
the lip or flange from both sides (17.1, 17.2). You
can make the cuts with a hacksaw. You can also
use a grinder, jig saw, or a Sawzall instead of a
hacksaw.
47. Lightly file the edges where both cuts were made to
remove any burrs. At this point you may want to
repaint the bracket. Strip the rest of the paint, get rid
of the rust, and then spray it with a good high temp
automotive primer. Finish coat should be black.
48. Reattach the modified bracket to the heat shield
using the two original Phillips head screws.
This concludes Part 3 of the installation.
Page 9 of 52