Powerplus POWX357 PAINT SPRAY STATION 900W EN - Manual (Page 6)

POWX357
EN
Copyright © 2012 VARO P a g e | 6 www.varo.com

Do not spray any liquid of unknown hazard potential. Unknown materials can create
hazardous conditions.

Wear additional protective equipment such as appropriate protective gloves and protective
masks or respirators when spraying or handling chemicals. Wearing protective equipment
for the appropriate conditions reduces the exposure to hazardous substances.

Never point the spray jet against yourself, towards other persons or animals. Keep your
hands and other body parts away from the spray jet. If the spray jet should penetrate the
skin, seek medical attention immediately from a doctor. The material being sprayed can
even penetrate the skin through a glove and be injected into your body.

Do not treat injection as a simple cut. Highpressure spray is able to inject toxins into the
body and cause serious bodily injury. In the event that injection occurs, seek medical
attention immediately.

Be aware of possible hazards from the spray material. Observe the information on
drums/tanks/tins as well as manufacturer information of the spray material, including the
request to wear personal protective equipment. The manufacturer's instructions are to be
observed in order to reduce the risk of fire as well as injuries caused through toxins,
carcinogens, etc.

Use only nozzles/nozzle inserts specified by the manufacturer. Never spray without the
nozzle protection mounted. Use of a special nozzle insert with the corresponding nozzle
protection reduces the probability that a high-pressure jet penetrates the skin and injects
toxins into the body.

Exercise caution when cleaning and changing nozzle inserts. If the nozzle insert should
become clogged during spraying, follow the manufacturer's instructions for switching off
the system and relieving the pressure before removing the nozzle. Fluids under high
pressure can penetrate the skin, inject toxins into the body and lead to serious injury.

Keep the plug of the mains cord and the trigger switch of the spray gun clear of paint and
other fluids. Never hold the cord by its connectors to support it. Failure to follow the
instruction can lead to electric shock.
We accept no responsibility for damage caused by the use of unsuitable
substances, or paints that have not been thinned correctly, and any health
hazards that arise from lack of adequate ventilation
6.1 Immediately switch off the spray gun when :

Interruption in the mains plug, mains lead or mains lead damage.

Defect switch.

Smoke or stench of scorched isolation.
7 ASSEMBLY
7.1 Preparation (fig 1.)
Do not use textured wall paints or coatings as this will block the nozzle.
To obtain the best results, it is important that you prepare the surface to be sprayed and thin
the paint to the correct viscosity, before you operate your spray gun. Always ensure that the
surfaces to be sprayed are free from dust, dirt and grease. Make sure that you have masked
the areas that should not be sprayed, using a good quality masking tape. The paint or fluid to
be sprayed should be thoroughly mixed and free from lumps or other particles. Many
substances can be sprayed with your spray gun, but always check the manufacturers
recommendations before purchasing your paint.