Powerplus POWX357 PAINT SPRAY STATION 900W EN - Manual (Page 9)

POWX357
EN
Copyright © 2012 VARO P a g e | 9 www.varo.com
Our machines have been designed to operate over a long period of time with a minimum of
maintenance. Continuous satisfactory operation depends upon proper machine care and
regular cleaning.
9.1.1 Taking Out of Operation and Cleaning (Fig. 14)
a: Air cap
b: Union nut
c: Nozzle

Turn the machine off. Activate the trigger guard so that the coating material in the spray
gun flows back into the container.

Unscrew the container. Empty any remaining coating material back into the material tin.

Pre-clean the container and feed tube with a brush.

Pour solvent or water into the container. Screw the container back on.

Use only solvents with a flashpoint over 21°C

Turn on the machine and spray the solvent or water into a container or a cloth.

Repeat the above procedure until the solvent or water emerging from the nozzle is clear.

Turn the machine off.

Then empty the container completely. Always keep the container seal free of coating
material residue and check for damage.

Clean the outside of the spray gun and container with a cloth soaked in solvent or water.

Unscrew the union nut and remove the air cap and nozzle. Clean the air cap and nozzle
with a brush and solvent or water.
Caution! Never clean nozzle or air holes in the spray gun with sharp metal
objects.
9.1.2 Re-assembling the nozzle (Fig. 15)
a: rib
b: groove
Put the nozzle onto the gun body and find the correct position by turning it. The rib on the
enclosure should fit into the groove on the nozzle. Put the air cap onto the nozzle and tighten it
using the union nut.
9.2 Entretien (Fig 16)
Change the air filter if it is soiled. Release the cover fastening from the machine place the air
filter (1) in the cover. Push the cover back onto the machine.
WARNING! Never operate the machine without the air filter; dirt could be
sucked in and interfere with the function of the machine.
10 TECHNICAL DETAILS
Model nr. POWX357
Voltage 220-240V
Frequency 50Hz
Power input 900W
Maximum nozzle flow rate 800gr/min
Container capacity 700ml
Nozzle diameter 2.6mm
Max viscosity 90 DIN/s