Powerplus POWX357 PAINT SPRAY STATION 900W EN - Manual (Page 8)

POWX357
EN
Copyright © 2012 VARO P a g e | 8 www.varo.com
8.2 Adjust the spray setting on the spray gun.
Three different spray jet settings can be chosen on the spray gun, depending on the
application and target object.
8.2.1 Selecting the Spray Setting
Fig. 6 = vertical flat jet ➟ for vertical surfaces
Fig. 7 = horizontal flat jet ➟ for horizontal surfaces
Fig. 8 = circular jet ➟ for corners, edges and hard-to-reach surface.
Fig. 9 = Wrong settings.
WARNING! Danger of injury! Never pull the trigger guard while adjusting the
air cap.
Attention: Only one direction is applicable when changing setting. Do not
force or will cause damage!

Change horizontal flat jet to Vertical. Counter clockwise rotate the changing button 90 ° .
(Fig. 10)

Change Vertical flat jet to horizontal. Clockwise rotate the changing button 90 ° . (Fig. 10)
8.3 Adjusting the Material Volume (Fig. 11)
Set the material volume by turning the regulator on the rear part of the spray gun. A scale on
the regulator serves as a guide:
+ turn to the right
➟ higher material volume
- turn to the left ➟ lower material volume
8.3.1 Spray Technique

The spray result depends heavily on the smoothness and cleanliness of the surface to be
sprayed. Therefore the surface should be carefully prepared and kept free of dust.

Cover all surfaces not to be sprayed.

Cover screw threads or similar parts of the target object.

It is advisable to test the spray gun on cardboard or a similar surface to find the correct
setting. Important: Begin spraying outside of the target area and avoid interruptions inside
the target area.

Correct (Fig. 12 a) Be sure to hold the spray gun at an even distance of approx. 2.5- 30
cm to the target object.

Incorrect (Fig. 12 b) Heavy spray fog build-up, uneven surface quality.

An even movement of the spray gun results in an even surface quality.

When coating material builds up on the nozzle (A) and air cap (B) (Fig. 13), clean both
parts with a solvent or water.
8.3.2 Interruption of Work

Turn the machine off.

Put the spray gun in the spray gun holder.
9 CLEANING AND MAINTENANCE
Make sure that the machine is not live when carrying out maintenance work
on the motor.