Powerplus POWXG2015 HEDGE TRIMMER 25,4CC 600MM EN - Manual (Page 10)

POWXG2015 EN
Copyright © 2014 VARO P a g e | 10 www.varo.com
9 MAINTENANCE
Our machines have been designed to operate for a long period of time with a minimum of
maintenance. Continuous and satisfactory operation presupposes proper machine care and
regular cleaning.
System /
component
Procedure
Before
use
Every
25
hours Every
50
hours Every
100
hours
note
E
n
g
ine
Fuel leaks, fuel
spillage
Wipe up V
Fuel tank, air
filter, fuel filter Inspect/clea
n
V V
Replace if
necessary
Idle adjusting
screw
See
adjusting
idling speed
V
Replace
carburettor if
necessary.
Sparking
plug
Clean and
readjust
electrode
gap
V
GAP: 0,6-
0,7mm,
replace if
necessary
Cylinder fins,
intake air cooling
vent
Clean V
Silencer, spark
arrester, cylinder
exhaust port
Clean V
S
h
a
ft
Throttle lever,
ignition switch Check
operation
V
Cutting parts
Replace if
something is
wrong
V
Gearbox Grease V
Screw/nuts/bolts
Tighten/repl
ace
V V
Not adjusting
screws
Warning: Before cleaning, inspecting, or repairing the unit, make sure that
the engine has stopped and is cool.
9.1 Blade lubrication
Warning: before lubricating, be sure your unit is switched off and that the
blade has come to a complete stop.
For easier operation and longer blade life,
lubricate the blade before and after each use.
Apply light machine oil along the edge of the
blade bar.