Powerplus POWXG2015 HEDGE TRIMMER 25,4CC 600MM EN - Manual (Page 8)

POWXG2015 EN
Copyright © 2014 VARO P a g e | 8 www.varo.com
 Hold the unit down firmly so that you will not lose control while cranking the engine. If not
held down properly, the engine could make you lose your balance or swing the cutting
blade into a nearby object or your body.
 Pull out the starter handle slowly (10 to 15 cm), and check the pressure. Pull strongly
when you feel the pressure and start the engine.
 When the engine starts, return the choke lever to ”
". Please note that the choke lever
will return to " " position automatically when the throttle lever is moved and the throttle is
opened.
 Run the engine for approximately one minute at a moderate speed before moving up to
full speed.
Note: When restarting the engine immediately after stopping it, leave the
choke open.
Note: Overchoking can make it hard to start the engine due to excess fuel. If
the engine fails to start after several attempts, open the choke and pull the
rope again, or remove the sparking plug and dry it.
8.1.2 Hot starting
Restarting immediately after the engine has stopped. When restarting a hot engine, first try the
above procedure: 1,2,4,5,6. If the engine does not start, repeat the above steps
Do not pull the rope to the end or return it by releasing the knob. This can
cause starter failures.
8.2 Stopping the engine
 Release the throttle lever completely.
 Move the engine switch to the “O (3)” position.
The engine will now slow down and stop.
Note: If the engine does not stop after moving the switch, close the choke to
make it stop..