Powerplus POWXG2015 HEDGE TRIMMER 25,4CC 600MM EN - Manual (Page 12)

POWXG2015 EN
Copyright © 2014 VARO P a g e | 12 www.varo.com
Important: When dismounting the plug cap, be careful not to remove the
seal. Operating the engine without the seal may cause the engine to
overheat.
Important: When inserting the sparking plug, first screw it in with your
fingers, and then tighten it with the help of a suitable plug spanner.
Overtightening will damage the cylinder and the piston.
9.6 Gearbox
Apply multipurpose grease after every 25 hours of use.
9.7 Silencer
9.7.1 After 100 hours of use
Check to see if any oil or grease has worked its
way in between the clutch lining and drum, and if
it has, wipe it away using oil-free and unleaded
petrol.
9.7.2 Maintenance before storage
Use a dry rag to wipe away any fuel which has
been spilt onto the unit.
 Extract fuel from the tank and run the engine until it stops naturally.
 Remove the sparking plug and put in 1-2cc of 2- stroke oil in the
engine. Pull the starter rope 2-3 times, set the plug back, and stop it
at the contraction position.
 Apply anti-rust oil to the metal parts such as the throttle wire, etc.,
put the cover on the blade, and keep it indoors to avoid exposing it
to dampness.
10 CLEANING
 Use a damp cloth to clean the plastic parts.
 Do not use any detergents, solvents or pointed objects.
11 STORAGE
So that the hedge trimmer will work again after a long period of inactivity, you should
observe the following points:
 Empty the petrol tank. To do this, start the engine and let it run until it reaches a standstill.
Dispose of the remaining petrol in an environmentally friendly way.
 Let the engine cool and take out the sparking plug.
 Pour a small spoonful of 2-stroke mixture into the sparking plug opening and slowly pull
the starter cord right through to the end several times. This gets rid of small deposits of
rust and lubricates the piston and cylinder.