Powerplus POWXG3016 BRUSH CUTTER 42,7CC EN - Manual (Page 12)

POWXG3016
EN
Copyright © 2014 VARO P a g e | 12 www.varo.com
When the inside of the fuel tank is dirty, it can be cleaned by rinsing the tank
out with gasoline.
11.3 Carburettor adjustment
The carburettor was pre-set at the factory for optimum performance.
When further adjustment is necessary, contact the service department.
12 TECHNICAL DATA
POWXG3016
Engine type Air-cooled, 2 stroke engine
Engine displacement 42,7cc
Max spindle speed 9500 rpm
Cutting width spool
Cutting disc
430mm
255mm
Knife 3 tanden
Handle “Bike” handle
Fuel tank capacity 1000 ml
13 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA 93 dB(A)
Acoustic power level LwA 113 dB(A)
ATTENTION! Wear hearing protection when sound pressure is over 85 dB(A).
aw (Vibration) 7,8 m/s² K = 1,5 m/s²
14 STORAGE
WARNING: Failure to follow these steps may cause varnish to form in the
carburettor and lead to difficult starting or permanent damage after storage.
 Clean outside surface of unit.
 Drain fuel from the fuel tank.
 After fuel is drained, start engine.
 Run engine at idle until unit stops. This will purge the carburettor of fuel.
 Allow engine to cool (approx. 5 minutes).
 Using a sparking plug wrench, remove the sparking plug.
 Pour 1 teaspoon of clean 2-cycle oil into the combustion chamber. Pull starter rope slowly
several times to coat internal components. Replace sparking plug.
 Store unit in a cool, dry place away from any source of ignition such as an oil burner,
water heater, etc.
 Put the sleeve on when not in use or in transportation.