Powerplus POWXG3016 BRUSH CUTTER 42,7CC EN - Manual (Page 13)

POWXG3016
EN
Copyright © 2014 VARO P a g e | 13 www.varo.com
15 REMOVING A UNIT FROM STORAGE
 Remove sparking plug.
 Pull starter rope briskly to clear excess oil from combustion chamber.
 Clean and gap sparking plug or install a new sparking plug with proper gap.(Fig. 24)
 Prepare unit for operation.
 Fill fuel tank with proper fuel / oil mixture. See Fuel and Lubrication Section.
16 TROUBLE SHOOTING
PROBLEM PROBABLE CAUSE CORRECTIVE ACTION
Unit won’t start or
starts but will not run.  Incorrect starting
procedures.
 Incorrect carburetor
mixture adjustment
setting.
 Fouled sparking plug.
 Empty fuel tank.
 Primer bulb was not
pressed enough.
 Follow instructions in the User
Manual.
 Have carburetor adjusted by an
Authorized Service Centre.
 Clean/gap or replace plug.
 Fill fuel tank with properly
mixed fuel.
 Press primer bulb fully and
slowly 10 times.
Unit starts, but
engine has low
power.  Fuel filter is plugged.
 Incorrect lever position.
 Dirty spark arrester
screen.
 Dirty air filter.
 Incorrect carburetor
mixture adjustment
setting service dealer.
 Replace the fuel filter.
 Move to RUN position.
 Replace spark arrester screen.
 Remove, clean and reinstall
filter.
 Have carburetor adjusted by an
Authorized Service Centre.
Engine sputters.
 Incorrect carburetor
mixture adjustment
setting.
 Air filter is blocked.
 Old or improperly mixed
fuel.
 Have carburetor adjusted by an
Authorized Service Centre.
 Replace or clean the air filter.
 Drain gas tank/add fresh fuel
mixture.
No power under load.  Incorrect carburetor
mixture adjustment
setting.
 Old or improperly mixed
fuel.
 Air filter is blocked.
 Fouled sparking plug.
 Have carburetor adjusted by an
Authorized Service Centre.
 Drain gas tank /add fresh fuel
mixture.
 Replace or clean the air filter.
 Clean/gap or replace plug.
Runs erratically.
 Incorrectly gapped
sparking plug.
 Blocked spark arrester.
 Dirty air filter.
 Clean/gap or replace plug.
 Clean or replace spark arrester.
 Clean or replace air filter.
Smokes excessively.
 Incorrect carburetor
mixture adjustment
setting.
 Incorrect fuel mixture.
 Have carburetor adjusted by an
Authorized Service Centre.
 Use properly mixed fuel (40:1
mixture).