Powerplus POWXG3016 BRUSH CUTTER 42,7CC EN - Manual (Page 6)

POWXG3016
EN
Copyright © 2014 VARO P a g e | 6 www.varo.com
 Never remove the fuel cap or add fuel with the power source running. Allow engine
exhaust components to cool before refueling.
 Do not smoke.
 Never refuel the machine indoors.
 Never store the machine or fuel containers inside, where is an open flame, such as a
water heater.
 If fuel is spilled, do not attempt to start the power source, but move the machine away
from the area of spillage before starting.
 Always replace and securely tighten the fuel cap after refueling.
 If the tank is drained, this should be done outdoors.
 Keep the handles free from oil and fuel.
 Do not smoke while mixing fuel or filling tank.
 Never start or run the engine inside a closed room or building. Exhaust gas contain
dangerous carbon monoxide.
 Never attempt to make engine adjustments while the unit is running and strapped to the
operator. Always make engine adjustments with the unit resting on a flat, clear surface.
 When the machine is placed in storage for a long time, drain fuel from the fuel tank and
carburetor, clean the parts, move the machine to a safe place and confirm that the engine
is cooled down.
7 SPECIFIC SAFETY WARNINGS
 BLADE CAN RECOIL VIOLENTLY FROM MATERIAL IT CANNOT CUT – Blade can
cause you to lose arms or legs. Keep people and animals 30 feet (10 meters) away in all
directions. If blade contacts foreign objects during operation, turn off engine and allow
blade to come to a halt. Then check blade for damage. Always discard blade if it is warped
or cracked.
 BLADE CATAPULTS OBJECTS THROUGH AIR - You can be blinded or injured. Wear
eye, face, and leg protection. Always clear work area of any foreign objects before using
blade. Keep people and animals 10 metres away in all directions.
 BLADE COASTS AFTER THROTTLE IS RELEASED - A coasting blade can injure you or
bystanders. Before servicing the blade, always turn off engine, and be sure coasting blade
has stopped.
 WARNING DO NOT USE ANY OTHER FUEL than that recommended in your manual.
Always follow instructions in the Fuel and Lubrication section of this manual. Never use
petrol unless it is properly mixed with 2-cycle engine lubricant. Permanent damage to
engine will result, voiding manufacturer’s warranty.
 DO NOT USE ANY OTHER CUTTING ATTACHMENT. Only use our replacement parts
and accessories, which are designed specifically to enhance the performance and
maximize the safe operation of our products. Failure to do so may cause poor
performance and possible injury. Use only the stringhead supplied with this product. Do
not use any other cutting attachment. Use of such attachments will void your factory
warranty and may result in serious bodily injury.