Powerplus POWXG3016 BRUSH CUTTER 42,7CC EN - Manual (Page 8)

POWXG3016
EN
Copyright © 2014 VARO P a g e | 8 www.varo.com
8.4.2 Assembly spool
 Install the flange washer and cup washer
on the spindle shaft.
 Install the spool and tighten it.
STOP ENGINE IMMEDIATELY!
Excessive vibration of blade
means that it is not properly
installed-stop engine immediately
and check blade. Blade not
properly installed will cause injury.
9 FUEL AND LUBRICATION
9.1 Fuel
Use regular grade unleaded petrol mixed with 40:1 custom 2-cycle engine oil for best results.
Use mixing ratios in Section FUEL MIXING TABLE below.
WARNING: Never use normal petrol in your unit. This will cause permanent
engine damage and void the manufacturer’s warranty for the product. Never
use a fuel mixture that has been stored for over 90 days.
WARNING: 2-cycle lubricant must be a premium grade oil for 2-cycle air
cooled engines mixed at a 40:1 ratio. Do not use any 2-cycle oil product with a
recommended mixing ratio of 100:1. If insufficient lubrication is the cause of
engine damage, it voids the manufacturer’s engine warranty.
9.2 Mixing fuel
Add oil to an approved fuel container followed by the petrol to allow incoming petrol to mix with
oil. Shake container to ensure thorough mix.
WARNING: Lack of lubrication voids engine warranty. Petrol and oil must be
mixed at 40:1.
9.2.1 Fuel and lubrication symbols
9.2.2 Reccomanded fuels
Some conventional kinds of petrol are now blended with oxygenates such as alcohol or an
ether compound to meet clean air standards. The engine is designed to operate satisfactorily
with any petrol intended for automotive use including oxygenated petrol.