Epson Endeavor 468C - Manual (Page 150)

Diskette Drive Problems
If you see a diskette error message or have difficulty with a
diskette drive, follow these steps:
1. If you have problems with a new diskette drive that someone
else installed, consult that person about the problem.
2. If you installed the drive yourself, did you carefully follow all
the steps in Chapter 5? Review the instructions and check
all the cable connections to make sure you installed the
drive correctly.
3. Did you run the SETUP program and configure the correct
type of diskette drive for your system? (See Chapter 2 for
instructions.)
4. If the diskette drive is making loud or unusual noises, do not
attempt any further examination of it. Contact the Epson
Connection for assistance.
Hard Disk Problems
If you have a problem with a hard disk, it could be the result of
improper installation, incomplete disk preparation, or
corrupted data. Consult one of the following sections:
q Installing the drive
q Preparing the drive for use
q Accessing data on the drive.
Caution
If your hard disk has data on it, always be sure to back up
your data before reformatting or repartitioning the drive.
6-14 Troubleshooting