Epson Endeavor 468C - Manual (Page 36)

Starting the SETUP Program
To start SETUP, make sure there is no diskette in the diskette
drive; then turn on your computer. (If your computer is already
on, turn it off, wait 20 seconds, and then turn it on again.) After
the self test, you see the following prompt at the bottom of the
screen:
Press <Del> if you want to run SETUP
As soon as you see this message, press .
If you do not press within approximately five seconds,
the computer starts loading the operating system and you will
not be able to run SETUP. If this happens, reset the computer
and try again.
When you press [Delete), you’ll see a SETUP menu containing
these options:
1. Start operating system
2. Run SETUP
3. Set Password options
4. Display system board help
5. Load default SETUP values
6. SAVE settings and exit
7. Exit without saving settings
Type the number of the menu option you want to select, or use
or to move the cursor over the option you want to
select and press As you highlight each menu selection,
you’ll see a description of the option at the bottom of the screen.
Running the SETUP Program 2-3