Epson Endeavor 468C - Manual (Page 31)

7
Turning On the Computer
After you set up your system, you’re ready to turn on the
power. Check the following safety precautions to avoid
accidentally damaging your computer or injuring yourself:
q Do not connect or disconnect any peripheral device cables
(including the mouse or keyboard) or power cables unless
the computer power is off.
q Never turn off or reset your computer while a disk drive
light is on. This can destroy data stored on the disk.
q Never turn on the computer with a protective card in the
diskette drive.
q Always wait about 20 seconds after you turn off the power
before you turn it on again to prevent damage to the
computer’s electrical circuitry.
q Do not leave a beverage near your system. Spilled liquid
can damage the circuitry.
Follow these steps to turn on the system:
1. Turn your computer around so the front panel faces you.
Place your monitor, printer, and other devices in a
convenient arrangement.
2. If there is a protective card in the diskette drive, remove it.
3. Turn on the monitor, printer, and any other devices connected
to the computer.
1-12 Setting Up Your System